jetcareers

Go Back   jetcareers > General > Forum Tech Support

Closed Thread
 
Thread Tools Display Modes
Old December 30th, 2007, 00:55   #1
eagledriver101
Senior Member
 
eagledriver101's Avatar
 
Join Date: Jun 2007
Location: Salt Lake City Utah
Posts: 658
Default Wireless Network Help!@!@

Okay dumb question(s)


My house was wired for a CAT5 system… this is a kind of complicated so I’ll try my best to ‘dumb’ it down a bit.


Because I am with Direct TV and have their HD/DVR/Receiver, which requires 4 lines, my cable modem cannot be connected in my master bedroom via Coax cable. (Because DRTV needed the line). No problem, right? Wrong! I moved my modem down stairs to the utility closest where all the cables come in and out. I installed my modem have a connection, my ISP sees a connections, every thing A-OKAY on that side of things. When I plugged my comp to the Ethernet outlet I get no connection. Like its dead… or something. Called Comcast they said it’s not on their end, my wiring looks fine unless its cut behind some wall I don’t know about


Is there, or is there not anything special I need to do for the CAT5 system to work?

Secondly does a computer or server have to be plugged into the Wireless router for it to work? I purchased a wireless router, got the network setup. However, at this point I only have one computer in my Master Bedroom that has a wires USB 2.0 adapter. It’s shows its connected to my network, however, when I unplug the Ethernet cable it still shows connected, but it says “Unidentified Network”… Any scoop on this? Or should I just buy a cheap used computer and use that as a “server”?

Can I not just have the comp connected to the router wirelessy, and not have any 'hardwire' other than the modem itself?
__________________
“Good advice is always certain to be ignored, but that’s no reason not to give it”
eagledriver101 is offline  
Old December 30th, 2007, 04:32   #2
xpanterica
Junior Member
 
xpanterica's Avatar
 
Join Date: Jan 2004
Location: Southern California
Posts: 105
Send a message via AIM to xpanterica
Default Re: Wireless Network Help!@!@

Well, let's see here. Nothing needs to be physically hardwired to your wireless router other than the cable modem itself for your network to function. To configure the router, however, it's probably best to use an ethernet connection to any PC. Once the wireless utility has been properly configured, you can disconnect the hardwire ethernet cables and you should be golden. There is no need for a "server."

Now, the issue with hardwiring your PC to the cable modem... If you have a sure connection to the ISP then the issue is undoubtedly your computer's configuration, probably the way your TCP/IP stack is configured.

Most likely, your modem will dole out an IP address to your computer. You'll want to root around in your network settings to make sure that everything is set to obtain an IP address automatically. That goes for DNS servers as well. PM me if you're still having issues!
xpanterica is offline  
Closed Thread

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


All times are GMT -4. The time now is 23:22.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.1.0
©2008 jetcareers.com