View Single Post
Old January 31st, 2009, 02:10   #7
stl
Newbie
 
Join Date: Dec 2008
Location: Kansas City
Posts: 8
Default Re: CFI with "No flying at night restriction"

Quote:
Originally Posted by mshunter View Post
Read an interperit the regs carefully. You don't have to have the night necessarly solo. If you do the Multi Comm first, then add the single, the night time must only be performing duties of PIC, 61.129 (b)(4)(i).
So here is 61.129 (b)(4)

(4) 10 hours of solo flight time in a multiengine airplane or 10 hours of flight time performing the duties of pilot in command in a multiengine airplane with an authorized instructor (either of which may be credited towards the flight time requirement in paragraph (b)(2) of this section), on the areas of operation listed in Sec. 61.127(b)(2) of this part that includes at least--

(i) One cross-country flight of not less than 300 nautical miles total distance with landings at a minimum of three points, one of which is a straight-line distance of at least 250 nautical miles from the original departure point. However, if this requirement is being met in Hawaii, the longest segment need only have a straight-line distance of at least 150 nautical miles; and

(ii) 5 hours in night VFR conditions with 10 takeoffs and 10 landings (with each landing involving a flight with a traffic pattern) at an airport with an operating control tower.

So the conclusion is that instead learning the basics in a single, and then going to multi-engine, I do the opposite, i.e. start with a multi-engine and then get the single rating later? Is that right?

Also, I'm assuming that this applies to Part 61 only?
stl is offline   Reply With Quote